Leaking Mixer Tap? Find Where It Leaks and Fix It
By Emergency Plumb,
A leaking mixer tap wastes water and money, and a leak below the sink can rot a cupboard floor before anyone notices. Where the water comes out tells you which part has failed.
Short answer: Dripping from the spout means a worn cartridge or valve. Water round the base or under the handle means perished O-rings. Water in the cupboard below means the supply hoses or their connections. Turn off the isolation valves under the sink before you take anything apart.
Before you start
Close the two small valves on the hot and cold pipes under the sink with a flat screwdriver, a quarter turn each. If there are none, use the stopcock. Put the plug in so no small parts disappear down the waste.
Dripping from the spout
Single-lever mixers have one cartridge that controls both flow and temperature. When its ceramic discs scale up or wear, the tap drips when closed or is stiff to move. A new cartridge to suit the tap fixes it.
Two-handle mixers have a valve under each handle: a rubber washer in older taps, a ceramic disc in newer ones. Turn off one supply at a time to find which side drips. Our guide to fixing a dripping tap covers both types.
Leaking at the base or round the spout
A swivel spout sits on O-rings that wear as it turns. When they go, water seeps out round the base every time the tap runs. New O-rings of the right size, with a smear of silicone grease, cure it.
Leaking from under the handle
On a lever mixer this is usually the cartridge’s own seals. On a two-handle tap it is the gland or spindle seal. Both are repairable if the parts exist.
Water in the cupboard under the sink
Dry everything, run the tap, and feel along each flexible hose and joint with a tissue. Common causes:
- A loose nut where the hose meets the isolation valve
- A perished washer inside that nut
- A tired braided hose, often bulging or rusty, which should be replaced, not tightened
A leak that only shows when the waste is running is the trap or waste pipe, not the tap. See fixing a leaking sink.
Hard water and mixer taps
London’s water is hard, and scale is the main reason cartridges fail early. Cleaning the aerator on the spout now and then keeps the flow up, and a tap that is getting stiff to move is telling you its cartridge is next.
When to call us
If the tap won’t turn off at all, close the isolation valves or the stopcock and call 07861 933265. For a tap that needs parts tracking down, or one that is better replaced, see tap repair and replacement. There is no call-out fee: £110 for the first hour and £45 per half hour after, plus parts.
Questions people ask
Why is my mixer tap dripping from the spout?
On most modern mixers the cartridge inside has worn or picked up scale, so it no longer seals when closed. On older two-handle mixers it is a worn washer or ceramic disc in one of the two valves.
Why does my mixer tap leak at the base?
The O-rings that seal the swivel spout or the body have worn. Water escapes round the base each time the tap is used.
Why is there water in the cupboard under the sink?
Check the flexible hoses that feed the tap and the nuts where they meet the isolation valves. A weeping hose or a loose nut is common, and a hose with a bulge or rust on its braid should be replaced before it bursts.
Can I replace a mixer tap cartridge myself?
Often, if you can turn the water off at the isolation valves and identify the exact cartridge. Cartridges are made for specific taps, so take the old one with you or note the tap's make and model.
Is it worth repairing an old mixer tap?
If parts are available and the body is sound, usually yes. If the tap is a no-name model with no spare parts, or the body is pitted and corroded, a new tap can cost little more than chasing parts.