Skip to content
Open 24/7 for emergenciesCall 24/7 · 07861 933265
Call 07861 933265WhatsApp us

How to Descale a Saniflo in a Hard-Water London Home

By Emergency Plumb,

London’s tap water is hard, and every flush leaves a little limescale behind in a macerator: on the walls of the chamber, on the blades, inside the discharge pipe and on the membrane that tells the pump when to stop. A regular descale is the cheapest repair a Saniflo ever gets.

Short answer: Use a descaler made for macerators, never bleach or supermarket toilet cleaner. Switch the unit off, pour in the amount the bottle says, leave it for the time stated, then switch on and flush a couple of times. Do it regularly in London, more often if the unit is heavily used.

Signs it needs doing

  • A crust of scale in the toilet pan, especially around the waterline and the outlet.
  • The unit sounds as though it is working harder, or runs for longer after each flush.
  • Water goes down more slowly than it used to.
  • A faint smell from the pan or the unit.
  • The unit has started running on, or starting by itself. See why a Saniflo keeps running.

What to use

Saniflo makes its own cleanser and descaler, which it describes as phosphoric-acid based and safe for the rubber parts and moving parts inside. Other makers sell their own versions for their units. Whatever you use, it should say it is for macerators.

Don’t use household bleach, caustic drain unblockers or ordinary toilet cleaner. Saniflo specifically warns that bleach can damage the membrane over the pressure switch, which can make the unit run too long or overheat.

How to descale it

  1. Read the bottle. The amount and the time to leave it differ between products and units.
  2. Switch the unit off at its fused spur or plug, so it does not pump the descaler straight out.
  3. Pour the descaler into the toilet pan, or into the basin or shower if your unit only serves those.
  4. Leave it for the time the bottle gives. Don’t use the toilet or anything else connected to the unit meanwhile; a note on the door helps.
  5. Switch the unit back on and flush a couple of times to rinse the descaler through.

If the unit has never been descaled and is badly scaled up, it may take more than one treatment.

When descaling is not the answer

Descaling clears scale. It will not fix a worn non-return valve, a torn membrane, a burnt-out motor or something wrapped round the blades. If the unit hums without pumping, is blocked, or still runs on after a descale, switch it off and see our guide to a blocked Saniflo, or book our emergency Saniflo repair service. There is no call-out charge, and the rate is £110 for the first hour at any time of day.

Questions people ask

How often should I descale a Saniflo in London?

Saniflo says descaling must be done regularly, and more often in hard-water areas, but gives no single interval. London's water is hard, so treat it as a regular job rather than something you do when it breaks. If you see scale in the pan or the unit starts sounding laboured, it is overdue.

Can I use vinegar or bleach instead?

Don't use bleach or ordinary toilet cleaners. Saniflo warns that bleach can damage the rubber membrane over the pressure switch. Use a descaler made for macerators and follow the instructions on the bottle.

Do I need to switch it off?

Yes. The unit must not pump the descaler away straight away, so it is switched off at the spur while the product works, then switched back on and flushed. Follow the product's own instructions for amounts and timing.

Descaling didn't help. What next?

If the unit still runs on, pumps slowly or smells after a proper descale, the fault is probably mechanical, a worn non-return valve, a damaged membrane or a blockage. That needs the unit opened by an engineer.

Sources

  1. How do you maintain a Saniflo Pump?, SFA Saniflo
Call 07861 933265WhatsApp